6FC5247-0AA30-0AA0 (Fan kit for SINUMERIK 840D PL NCU)

The SLS oil skimmer gives you high separation of tramp oil and extends the lifetime of your cutting fluids.

The technique exploits the viscosity differential between oil and cutting fluid, with the more viscous oil clinging to a rotating threaded device, from where it is separated out.

With the screw action oil skimmer you can separate more than twice as much tramp oil per hour than with a traditional belt skimmer while scarcely removing any cutting fluid. Whereas the screw action oil skimmer separates out 1.7 liters of tramp oil, the result for the belt skimmer is just 0.65 liters over the same time.*

This new way of separating tramp oil is highly effective, gives you minimal loss of cutting fluids and has low maintenance requirements, low operating costs and a compact design.

*Results from a performance test conducted at one of the largest automotive companies in the world during a test period of 6 hours.

The SLS oil skimmer gives you high separation of tramp oil and extends the lifetime of your cutting fluids. The technique exploits the viscosity differential between oil and cutting fluid, with the more viscous oil clinging to a rotating threaded device, from where it is separated out. With the screw action oil skimmer you can separate more than twice as much tramp oil per hour than with a traditional belt skimmer while scarcely removing any cutting fluid. Whereas the screw action oil skimmer separates out 1.7 liters of tramp oil, the result for the belt skimmer is just 0.65 liters over the same time.* This new way of separating tramp oil is highly effective, gives you minimal loss of cutting fluids and has low maintenance requirements, low operating costs and a compact design. *Results from a performance test conducted at one of the largest automotive companies in the world during a test period of 6 hours.

Set of 16 extra buttons for Heidenhain HR 510 Handwheel.

- 16-piece accessories set - For adapting the key assignment of the handwheel - Included snap-on keys (one piece each) o Black: 5 x without symbol FCT A, FCT B, FCT C o Green: Spindle On, NC start o Red: NC Stop, Spindle stop o Orange: B, C o Gray: Spindle left, Spindle right

Ergonomic handwheel from Heidenhain, for i.a. iTNC 530, TNC 620 & TNC 640. Can replace i.a. HR 410.

Keypad I: X, Y, Z, IV, V, actual position capture Keypad II: 3x rapid traverse (slow, medium, fast) Keypad III: Minus, Plus Keypad IV: function A, function B, function C Keypad V: no specified value Clips keys: Permissive buttons: 2xNO/2xNO Emergency stop: 1 Number of magnetic holding pads: 2 Number of status LEDs: 12 Data transfer: Cable Electrical connection: Flange socket, male, 13-pin, with bayonett socket